Foxcon Terrier T200 LSA, Руководство по эксплуатации самолета, Страница: 20 / 31

Terrier T200 LSA Flight Manual Rev No.: 1.0 15 April 2008 Page 20 of 31
8.5 Fire
8.6 Fire during Start on Ground
1 Cranking CONTINUE to get a start that would suck the flames and
accumulated fuel through the carburettor and into the engine.
If engine starts,
2
Power 2500 RPM
3
Fuel OFF & allow engine to empty carburettor
4
Engine Inspect for damage
If engine fails to start,
5 Cranking CONTINUE in an effort to obtain a start. If no start in 15 seconds :
Shut off fuel & continue to crank for another 15 seconds.
6
Engine SECURE.
A Second Ignition Switch OFF
B Master Switch OFF
C Fuel Shutoff Valves Both OFF
7
Fire Extinguish using fire extinguisher, wool blanket, or dirt.
8 Fire Damage Have authorised people inspect, repair damage or replace
damaged components or wiring before conducting another flight.
8.7 Engine Fire in Flight
1 Throttle CLOSED
2 Fuel Shutoff Valves Both OFF
3 Ignition Switches OFF
4 Master Switch OFF
5 Cabin Air CLOSE
6 Airspeed 75 knots (if fire is not extinguished, increase glide speed to find an
airspeed which will provide an incombustible mixture).
7 Forced Landing Execute (as described in Emergency Landing Without Engine
Power).
8.8 Electrical Fire in Flight
1 Master Switch OFF
2 All Other Switches OFF
3 Vents/cabin air (*) OPEN THE CABIN DOOR
If fire appears out and electrical power is necessary for continuance of flight:
4 Master Switch ON
5 Second Ignition Switch ON
6 Fuses CHECK for faulty circuit, DO NOT reset or replace.
7 Radio/Electrical Switches ON one at a time, with delay after each switch until short
circuit is localised.
8 Land as soon as possible to inspect for damage
8.9 Cabin Fire
1 Master Switch OFF
2 Vents/Cabin Air (*) / Door OFF
3 Land as soon as possible to inspect for damage.