7
Take the same procedure as above.
When this feature is defaulted as enable (Select 120 or 180 seconds), the engine will be still running for 120(180) seconds after
turning the ignition off in order to protect the engine life.
When default Turbo Timer as 120 or 180 seconds,
a.
If the engine doesn’t run over 5 minutes, the turbo timer will not function.
b.
When the engine runs over 5 minutes, pull up the handbrake, then switch the ignition off, the engine will still run for another
120 or 180 seconds (depends on the default) and the system is still disarmed.
c.
During the period (120/180 seconds) of turbo timer, press button (1) once, parking lights will flash once and the siren chirp
once, the system is armed. During this period, the shock sensor will be bypassed. And the shock sensor will function
normally until the engine is shut down.
Remote Start Mode
Steps to default Remote Start Mode as Alternator or Tach:
Take the same procedure as above.
If Tach Sensing (RPM) programmed,
a)
Perform the tach learning at first time before remote start.
b)
Make sure the Tach wire(Green) of the alarm system shall be connected to the negative of the coil as shown in wiring
diagram.
Crank Time
Steps to default Crank Time as 0.6, 0.8 or 1 second:
Take the same procedure as above.
Normally, the old and diesel vehicles need longer crank time to start engine.
However, if the engine doesn’t start smoothly, please default the crank time longer.
Engine Running Time
Steps to default Start Running Time as 10 minutes or 20 minutes:
Take the same procedure as above.
Depending on the defaulted engine running time, the engine will run 10 or 20 minutes and shut down automatically.
Timer Start Mode
Steps to default 24-Hour Engine Start Mode as 3 hours, 6 hours or 12 hours:
Take the same procedure as above.
It is the most convenient feature to use in the cold winter season.
a) Press button (1) and (3) once at the same time to activate Timer Start Mode, then siren will chirp once, lights flash once to
confirm. Depending on the defaulted value, the engine will automatically start every 3, 6 or 12 hours in the 24-hour period.
b)
Press button (1) and (3) once again at the same time to deactivate this mode. Then siren will chirp twice and the parking lights
flash twice.
Followings are 3 situations that the timer start mode will be cancelled.
a)
When remote engine start.
b)
Doors are opened.
c)
The system is triggered.
Siren, Horn or No Siren
Steps to default Siren or Horn Output:
Take the same procedure as above.
a) If horn selected, one extra relay shall be added. If horn selected and defaulted, it has 0.5 second interval between each horn.
b) If siren output selected, the system will send constant outputs.
c) If no siren selected, the siren will not sound under any circumstance.
