4
Emergency Override Mode
As an emergency situation happens like the remote transmitters lost, you can override the full security system.
a)
Open the door by your car key and the alarm will be triggered.
b)
Switch the ignition on/off 6 times, the siren will be off and the system is disarmed.
Remote Valet Mode
This mode is a convenient feature to use when you hand the remote transmitter to third person for valet parking or vehicle service.
a)
When the system is disarmed, switch the ignition on and press button (1) and (2) once simultaneously, the siren will chirp
once and then the system enters into the valet mode. Under this mode, drivers can control only door lock/unlock.
b)
To quit the remote valet mode, switch the ignition on and press button (1) and (2) once simultaneously, the siren will chirp
twice and then the system will quit the valet mode.
Car Finder
a)
When the system is armed, press button (3) once, the parking lights will flash 12 times and siren will chirp 6 times, then the
system will remain under the arm mode.
b)
When the system is disarmed, press button (3) once, the parking lights will flash 12 times and siren will chirp 6 times, then
the system will remain under the disarm mode.
c)
Under the car finder mode, press button (1) or (2) once, the system will be armed or disarmed.
RPM (Tach) Learning
Before perform the RPM(Tach) learning, turn off all electrical devices such as car stereo, FM Radio or air conditioner.
By doing so, the system will learn lower RPM, which will make it smoother and easier when remote starts.
Take the following steps to perform the RPM learning.
a)
Shift the gear to the neutral position and pull up the hand brake.
b)
Switch the ignition on and start the engine.
c)
Wait until the PRM is running stably (normally vehicle’s stable RPM is 900-1,000.)
d)
Press button (1) and (3) simultaneously for 3 seconds. The parking lights will flash 2 seconds to confirm that
RPM is learned.
Important:
1.
Please make sure to default Start Mode as Tach (please refer to # 5 Remote Start Mode of
Programming Option section).
2.
The Tach wire (Green) of the alarm system shall be connected to the negative of the coil.
Remote Engine Start for Automatic Transmissions
Just press button (4) 3 seconds to remote start, the LED transmitter will chirp once.
If the remote start has not been successful more than twice, please check up the followings.
a)
The remote start will be activated only under the arm mode.
b)
Hood Open
c)
Trunk Open
d)
Door Open
e)
Foot brake pushed down
f)
Hand brake pulled down
The engine will shut off if the following cases happen to protect your vehicle after the remote start.
a)
Hood Open
b)
Door Open
c)
Trunk Open
d)
Foot brake pushed down
e)
Parking brake released
After remote engine start is succeeded, please follow the following steps to enter the vehicle.
a)
Insert the car key into the ignition then switch it to “On”, not Start.
The engine will shut down if apply foot or hand brakes before insert the car key into the ignition and switch
“On”.
Reservation Mode (Remote Engine Start for Manual Transmissions Only)
For the safety concern, the reservation mode is designed for the manual transmission cars.
The manual transmission shall be defaulted (refer to Car Type of Programming Option Section)
Take the following procedure to set up the reservation mode.
1.
After arriving at the destination, remain the ignition on and shift the gear to the neutral position
