Fox F36-528A, Инструкция по эксплуатации

Страница: 40 / 103

33
EN
USE
INTRODUCTION
•
Before using the saw blade, check that all protection and safety devices are assembled and work properly.
•
The machine must be stable and firmly fixed to the ground.
•
The saw blade must rotate freely.
•
If you want to cut workpieces that have already been processed, be careful that there are not any
extraneous parts as for example nails or screws.
•
Before starting the table saw, be sure that the blade is assembled correctly.
•
Before connecting the machine, ensure that the voltage corresponds to what it is marked on machine’s
data plate.
ON / OFF SWITCH (Fig. 6)
To start the table saw press the green button ”I” of the switch.
To switch off the saw, press the red button ”O” of the switch.
The switch of this machine is a “minimum voltage“ switch and prevents the start of the machine in case of
recovery of the electrical energy after an interruption. So, you must press the green button to re-start the saw
that has stopped.
ENGINE PROTECTION
The saw has a thermal cut-out to protect the engine. This device stops the engine’s power supply before the
temperature reaches a dangerous level for the winding. After the engine has cooled down, press the green
button to start again the saw.
SAW BRAKING SYSTEM
This tool has a mechanical brake that stops the blade in less than 10 seconds since when you push the button.
Check the efficiency of the brake periodically, and if it does not work take the machine to an after sales service.
CUTTING DEPTH (Fig. 13)
Rotate the handle (8) Fig. 13 which lifts of lowers the blade to adjust cutting depth.
Rotate the handle clockwise to increase cutting depth and anti-clockwise to decrease cutting depth. You can
check cutting height precisely by means of the graduated scale Fig. 13 .