Fox F36-527, Руководство по сборке и эксплуатации

Страница: 5 / 24

5
SPECIFIC SAFETY INSTRUCTIONS FOR SAWS
Do not use the bandsaw until it is completely assembled and installed according to the instructions in this manual.
If you are not completely familiar with operating saws, obtain help from a qualified person.
Replace table insert when worn.
Use only saw blades recommended by the manufacturer, which conform to EN 847-1.
When changing the saw blade ensure that the width of the groove cut of the saw blades shall not be less than, and
the thickness of the body of the saw blade shall not me more than the thickness of the riving knife.
Take care that the selection of the saw blade is suitable for the material to be cut.
Wear suitable personal protective equipment when necessary. This could include hearing protection to reduce the
risk of induced hearing loss and respiratory protection to reduce the risk of inhalation of harmful dust.
Wear gloves when handling saw blades and rough material. Saw blades should be carried in a holder whenever
practical.
Do not use High Speed Steel (HSS) blades.
The push stick or push block should always be stored with the machine when not in use.
Only use saw blades for which the maximum possible speed is not less than the maximum spindle speed of the tool
and the material to be cut.
When transporting the machine
lift only by handles or solid parts, never use gaurds to move or transport the
machine.
During transportation , the upper part of the saw blade should be covered by the guard.
If you need to use an extension cable,
make sure its conductor cross-section is large enough for the saw’s power
consumption. Minimum cross section : 1.0mm
2
.
After you have switched off the motor, never slow down the blade by applying pressure to its side.
Fit only blades which are well sharpened and have no cracks or deformations.
Faulty saw blades
must be replaced immediately.
If you are interrupted while operation the saw,
finish what you are doing and switch off the machine before looking
up.
Periodically check that all nuts, bolts and other fixings are properly tightened.
Always ensure that your work is on the table. Never use the tool to cut pieces that are not on the table.
Do not place your hands in awkward positions where one or both may slip suddenly and touch the saw blade.