FOX RACING SHOX FLOAT X EVOL, Руководство пользователя

Страница: 10 / 32

6
to pressurize your shock:
sTEp remove the EVOL air chamber cap to access the schrader valve .
sTEp 2
thread the high pressure pump (300Psi) chuck valve onto the schrader valve until pressure
registers on the pump gauge . this takes approximately six turns . do not over-tighten the
pump on the air valve as this will damage the chuck pump seal .
if the shock hAs no Air pressure, the gAuge will reAd zero.
when you AttAch the pump to the shock, the hose will need to
fill with Air. this mAy result in A pressure reAding thAt cAn be
lower by As much As 10 to 20 psi.
sTEp
stroke the pump a few times . the pressure should increase slowly . if pressure increases
rapidly, check to make sure the pump is properly fitted and tightened onto the air valve .
sTEp
Pump to the desired setting . the
EVOL
air chamber pressure is application specific, but
typically ranges from 100 Psi to 150 Psi . do not eXceed 300 Psi in the
EVOL
air chamber .
you can decrease pressure by pushing the black bleed valve on the pump . Pushing the bleed
valve half-way down and holding it there will allow air to escape from the pump and shock .
Pushing the bleed valve all the way down and releasing it will allow only a small amount of
pressure to escape (micro-adjust) . When unthreading the pump from the schrader valve,
the sound of air loss is from the pump hose, and not the shock .