![FOX RACING SHOX 32mm Forx Скачать руководство пользователя страница 6](http://html1.mh-extra.com/html/fox-racing-shox/32mm-forx/32mm-forx_owners-manual_2324977006.webp)
2006 FOX FORX OWNER’S MANUAL |
P/N: 605-00-044
6
Disc
Disc brakes with 160 – 203 mm rotors can be used on
FOX 32MM FORX
. Do not use rotors larger than 203 mm. Install disc brakes and torque all fasteners
according to manufacturer’s specifications. Install, route and check that all cables or hydraulic hoses are securely fastened to the lower leg and will
not move during compression of the fork. It is recommended that new disc brake pads be installed to ensure proper alignment and to minimize drag.
Test brakes for proper operation on flat land.
TORQUE CALIPERS TO BRAKE MANUFACTURER'S SPECIFICATIONS.
5. Mount the front wheel. Check that the quick-release nuts sit in the fork dropout counterbores. The quick-release should engage four (4) or more threads.
Close the quick-release with the lever in front of and parallel to the left fork leg.
TIRE SIZES
FOX 32MM FORX
will accept tire sizes up to 2.40 inches wide (e.g., WTB MotoRaptor 55/60, 26 x 2.40). Any tire
larger than 26 x 2.30 must be checked for clearance using the following method:
Determining correct tire size
With the tire installed and inflated on the rim, measure the following three dimensions:
Maximum Peak Tire Diameter = 686 mm = 27.00 inch
Maximum Edge Tire Diameter = 652 mm = 25.67 inch
Maximum Tire Width =
61 mm
= 2.40 inch
DO NOT USE A TIRE IF ANY MEASUREMENT EXCEEDS THE MAXIMUM
DIMENSIONS SHOWN ABOVE. USING LARGER TIRES IS NOT
RECOMMENDED AND CAN CAUSE SERIOUS OR FATAL INJURIES.
FORK TERMINOLOGY
>
TRAVEL
: total amount the fork compresses
>
SAG
: amount the fork compresses with the rider sitting on the bike in a normal riding position.
>
COMPRESSION DAMPING
: controls the rate at which the fork compresses.
>
REBOUND DAMPING
: controls the rate at which the fork extends.
>
PRELOAD
: initial force placed on a spring.
>
SPRING RATE
: force required to compress a spring one inch.
ADJUSTING REBOUND
(ALL FORK MODELS)
The rebound knob is the red knob located on top of the right fork leg, and has 12 clicks of adjustment. Rebound controls the speed at which the fork extends
after compressing. Turning the knob clockwise slows down rebound; turning the knob counterclockwise speeds up rebound.
As a starting point, turn the rebound adjuster knob all the way clockwise until it stops, then turn counterclockwise 6 clicks.
REBOUND
Knob Setting
(clicks OUT from full in)
Setting
Description
Tuning Tips
Setup Tips
Maximum
Peak Tire
Diameter
Maximum
Edge Tire
Diameter
Tire Width
Содержание 32mm Forx
Страница 1: ......
Страница 26: ...2006 FOX FORX OWNER S MANUAL P N 605 00 044 26 TUNING NOTES ...
Страница 27: ...P N 605 00 044 2006 FOX FORX OWNER S MANUAL 27 ...