Four winns SL series, Руководство пользователя

Страница: 133 / 175

Owner’s Manual Page 130 Trailer Information - Section S
NOTICE
DO NOT use a bent or damaged tongue or
cou pler. Re place ment parts may be ordered
through a Four Winns dealer.
The trailer tongue is hinged or removable on our
painted trailers and galvanized trailers. This allows
for easier storage. The tongue is at tached with clevis
pin(s) with locking hair pin(s) or clevis pin keeper(s)
to the trailer frame. Refer to Figure S3.
Figure S3: Trailer Tongue Assembly
To pivot the tongue on trailers models with exposed
hinges:
1. Make sure the trailer jack is supporting the trailer
load properly. Refer to Section S-2C on Swivel
Jacks for additional information.
2. Disconnect the trailer from the tow vehicle.
3. Unplug the trailer’s wire harness from the tow
vehicle’s trunk connector.
4. Remove the clevis pin keeper and clevis pin.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push
or wiggle the tongue to remove the clevis pins.
5. Pivot the tongue towards the trailer as far as
it will go.
To reinstall, follow this procedure in reverse order.
1. Pivot the tongue until the clevis pin holes
aligned.
Lock Pin
NOTICE
When extending tongue ensure that the
brake line and wire harness are not pinched.
Failure to check could result in damage.
2. Insert clevis pin. Always be sure to insert
clevis pin from the top and insert the clevis
pin keeper.
NOTICE
The tongue will exert some pressure on the
clevis pins. It may be necessary to lift, push or
wiggle the tongue to insert the clevis pins.
Make sure the trailer tongue is secure before
hitching to the towing vehicle.
4. If towing the trailer, remember to plug the
5-wire tongue harness to the trunk connector
wire harness of your tow vehicle.
C. Swivel Jack
The jack is designed to lift, lower and support the
tongues of the trailers when not connected to the
towing vehicle. Before unhitching the trailer, use the
following guidelines when setting up the jack.
1. Pull on the lock pin. See Figure S4.
Figure S4: Swivel Jack
2. Swivel jack to the vertical posi tion.
3. Release the lock pin and make sure the pin fully
engages the attached tongue bracket.