Four winns HORIZON, Руководство пользователя

Страница: 79 / 131

Section M
Page 4
180/190/200 Horizon
Owner’s Manual
08/01
3. Rotate the bucket seat inboard until it locks into the
forward facing position. In addition, DO NOT USE
FORCE to rotate the chair.
4. Position the seat forward or aft according to the
needs of the individual by using the lever located
underneath the seat, at the center. See Figure M8.
5. Tilt the steering wheel (if applicable) to the desired
position using the tilt lever knob on the steering col-
umn.
DO NOT sit on the backrest portion of any cock-
pit seat. The operator could lose control of boat
or passengers could be thrown from boat. Also,
the seat may be damaged from improper use.
G. Sundeck (Sunsport Seating Option)
On the Horizon® Sunsport models, the sundeck is one
complete piece that runs the entire width (beam) of the
boat. The sundeck can be used for sunbathing and is
supported by bulkhead and other supports. It is secured
by a latch mechanism. A gas shock or hydraulic sup-
port assists in raising the sundeck and keeps the
sundeck in the raised position while storing gear or for
maintaining the engine. See Figure M9.
To lift the sundeck, pull the strap of the sundeck cushion
latch and lift up the sundeck using your other hand.
To close the sundeck, lower the sundeck gently into the
closed position. Place both hands on top of the cushion
directly over the latch mechanism and push down to
ensure the latch engages the striker.
Figure M9: Sundeck Assembly
NOTICE
Never operate your boat with the sundeck and
or top storage in their open position. Doing so
could result in damage or loss of cushion and
hardware. This is also true when trailering your
boat. Cushions, if not properly stored and
secure, will blow out of the boat.
H. Sunsport Couch
The couch assembly is part of the optional Sunsport in-
terior. On all sunsport models the bench seat slides out
to create additional berthing or sunbathing space. A
shock cord is attached to the couch cushion and a
bungie knob is placed on the couch support base. Loop-
ing the shock cord around the knob will prevent the
couch from accidentally sliding out when running in
choppy water.
Figure M10: Couch Assembly
M - 2 EXTERIOR UPHOLSTERY CARE
The vinyl material used on the exterior upholstery can
be easily cleaned using mild detergent and water. Be
sure to thoroughly rinse the seats after washing to re-
move all soap film. Periodic spraying of the seats with
Lysol Spray Disinfectant™ will help retard mildew.
NOTICE
DO NOT apply vinyl protectants such as
Armoral™. The manufacturer does not recom-
mend this product because it removes the oils
present in vinyl that keeps vinyl soft.
A recommended “Cleaning Kit” includes:
• Ivory Dishwashing Liquid™ and water
• Clean, white towels
• Medium-soft brush
Sundeck
Strap
Shock Cord
Bungie Knob