F8L10T LoRa Terminal User Manual
Xiamen Four-Faith Communication Technology Co.,Ltd.
Page 15 of 18
Add
：
11th Floor, A-06 Area, No.370, Chengyi Street, Jimei, Xiamen, Fujian, China.
http://en.four-faith.com
Tel
：
+86 592-5907276 Fax
：
+86 592-5912735
Chapter 3 Configuration
3.1 Configure connection
In the Lora digital transmission terminal configuration, the need to pass the factory
configuration RS232 serial cable or RS232-485 conversion line Lora data transmission terminal
and configured to connect the PC together, as follows:
Figure 3-1 F8L10T configuration connection with PC
3.2 Introduction of parameter configuration
F8L10T parameter configuration in two ways:
Through the Four-Faith configuration software LoRaConfig: all configuration is
configured with the corresponding entry software interface, this configuration is only
suitable for professional Installer to facilitate the configuration of PC Case.
By extending the at command (hereinafter referred to as the AT command) way to
deploy: in this configuration, the professional Installer only needs to have the serial
communication program can configure all parameters such as F8L10T, windows of
the super terminal, Linux minicom, putty, or directly by the user's SCM system to
node configuration. In the use of extended at command to configure F8L10T to bring
F8L10T into the configuration state.
Among them, AT command configuration can refer to "AT command manual".
Configure the f8l10t parameters by configuration software, as shown in Figure 3-2.
