Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 123 / 198

Maintaining the Hardware
December 2008 © 2008 Foundry Networks, Inc. 7 - 9
3. Pull the card ejectors towards you, and away from the module front panel. This action unseats the module
from the backplane.
4. Pull the module out of the chassis, and place in an anti-static bag for storage if desired.
5. If you plan to replace the removed module with a different type of module, you must first remove the module
configuration. To do so, enter the no module <slotnum> command at the global CONFIG level of the CLI,
then save the configuration to flash memory. For example:
FastIron(config)# no module 4
FastIron(config)# exit
FastIron# write mem
NOTE: If you attempt to insert a module of a different type without first removing the previous module
configuration, the system will display an error message.
6. Install a new module in the slot. For information about performing this task, see “Installing a New Interface
Module”.
CAUTION: If you do not install a module in a slot, you must keep the slot panel in place. If you run the
chassis with an uncovered slot, the system will overheat.
Installing a New Interface Module
You can install an interface module in the FSX 800 and FSX 1600 chassis while the chassis is powered on and
running. This also applies to the FSX running software release 02.2.01 or later.
NOTE: The interface modules are interchangeable among all FastIron X Series chassis devices. However, if
you try to install them in a Foundry chassis other than a FastIron X Series, the chassis and interface modules will
not function properly.
NOTE: Before installing one of these modules into the FSX chassis, have the following on hand:
• A new interface module, which you can order from Foundry.
• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.
WARNING: For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
• A #2 Phillips-head or flathead screwdriver.
To install a new interface module in the chassis, do the following:
1. Follow the preparation procedure in the section “Before Removing an Interface Module” on page 7-8.
2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector located in the
lower right corner of the chassis front.
3. Remove the module from its packaging.
4. Insert the module into the chassis slot as shown in Figure 7.6, and slide the card along the card guide until
the ejectors on either side of the module move close to the module front panel.
5. Push the ejectors in toward the center of the module. This action will fully seat the module in the backplane.
6. Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at either end of the module front
panel.
7. If you have installed a LAN/WAN Phy interface module, configure it as instructed in the section “Configuring a
LAN/WAN Phy Interface Module” on page 7-11.