3.Installation and removal of AC power adapter/battery holder
(1) Mount the AC power adapter or the battery holder onto the v-lock plate on the yoke.
(2) Remove the AC power adapter or battery holder by pressing the release button on the v-lock plate and slide
the AC power adapter or battery holder out of the v-lock plate.
V-lock plate release button
4.Power supply
(1) Insert the plug of AC power adapter into DC input socket on the light body and secure by turning clockwise.
To remove the AC power adapter, turn the adapter counterclockwise and pull it out.
(2) Connect the AC power cable to the AC power adapter. Then connect to external AC power ( AC100-240V).
(3) To use optional battery power: Follow above instruction for mounting the battery holder to the yoke. After the
battery holder is on the yoke, connect the battery adapter to the DC input socket on the light with the D-tap cable.
NP-F 750 batteries will power your light for approximately 70mins. When the batteries are exhausted, you can use
the battery holder for charging by connecting the 24V 1A battery charger adapter to the DC socket of the battery
holder. The charging time for NP-F750 batteries is approximately 3 hours.
Powered by AC power adapter
Powered by Battery holder
DC input socket
5.Operating instructions
(1) Power on the unit by toggling the ON/OFF switch on the body of the light. The LCD screen will now show
real-time brightness and color temperature data. If battery power is being used, the LCD will also display remaining
battery power level.
Brightness
Battery level
Color temperature
(4) Special effects mode operation
When the light is powered on, press the function adjustment knob for approximately 3 seconds to enter the special
effect mode function. Then turn it clockwise or counterclockwise to adjust between 11 different special effects modes:
F1, F2, F3... F11. When you have selected your special effect mode, press the function adjustment knob one to enter
brightness adjustment for that mode. Brightness can be adjusted from 0-100% in any special effect mode. To exit the
special effect mode, press the function knob for approximately 3 seconds..
Note: F1-Lightning mode, F2-Fireworks mode , F3-Flash mode, F4-Breath mode, F5-Cop car mode,
F6-SOS mode, F7- Fault light mode, F8-Turn signal mode, F9-Tracing mode, F10- Screen mode,
F11 : High and low beam mode.
(2) The PopSpot v.2 50 is dimmable from 0-100%. Increase brightness by turning the function adjustment knob
clockwise or decrease brightness by turning counterclockwise.
(3)
The right side of the LCD shows the battery level:
Four columns: 75%-100% Three columns: 50%-75%
Two columns: 25%-50% One column: 10%-25%
No column: 10% or less Flicker: power not enough
POP SPOT V.2
POP SPOT V.2
Power switch
Function adjustment knob
