Make sure, that the device is always positioned tilt and skid resistant and
stored securely.
−
Keep out of reach of children and animal. They could overturn the
device.
−
Avoid placing cables where they can be tripped over. The device could
be overturned.
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even
if it is switched off. Just after disconnecting the device from the power
supply through pulling out the power cable, the device is actually de-
energized.
−
Switch off your device when it is not in use.
−
Switch off your device before mounting and maintenance and
disconnect from power supply.
−
Discharge the device before starting any maintenance arrangements.
−
Protect your device against unintended switching-on.
−
Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through
humidity or moisture. A short-circuit can warm up the conductors, so that
there isolation will melt or even melt thoroughly. This could lead to fire.
Please just use the original cables, which are included in delivery. They
are aligned for your device and guarantee the necessary safety for you
and your device.
−
Don´t operate the device with wet hands or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning your device.
−
Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or nibbling
animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before
switching on again.
−
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord. Never
operate your device with damaged housing, damaged reflector, defect
modeling lamp, defect flash tube or damaged power cord. Don´t open
the device. Never repair the device on your own. The device should only
be repaired by electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
6
