background image

2

„

„

WARNINGS and PRECAUTIONS

• 

CAUTION: 

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO 

WIDE SLOT, FULLY INSERT.

• 

WARNING:

 To reduce the risk of fire or electric shock, do not expose this 

apparatus to rain or moisture.

• 

CAUTION: 

Use of any controls or adjustments or performance of procedures 

other than those herein specified may result in hazardous radiation exposure.

• 

WARNING: 

Changes or modifications to this unit not expressly approved 

by the party responsible for compliance could void the user’s authority to 
operate the equipment.

• 

WARNING: 

Do not place the unit on top of any soft, porous, or sensitive 

surfaces to avoid damaging the surface. Use a protective barrier between the 
unit and surface to protect the surface.

• 

WARNING: 

Use of this unit near fluorescent lighting may cause interference 

regarding use of the remote. If the unit is displaying erratic behavior move 
away from any fluorescent lighting, as it may be the cause.

• 

CAUTION: 

Danger of explosion if battery is incorrectly replaced. Replace only 

with the same or equivalent type.

• 

WARNING: 

Do not install this equipment in a confined space such as a book 

case or similar unit.

• 

WARNING: 

Mains plug is used as disconnect device and it should remain 

readily operable during intended use. In order to disconnect the apparatus 
from the mains completely, the mains plug should be disconnected from the 
mains socket outlet completely.

• 

Do not mix old and new batteries. Do not mix alkaline, standard (carbonzinc), 
or rechargeable (ni-cad, ni-mh, etc) batteries.

CAUTION

WARNING: 

TO REDUCE THE RISK OF ELECTRIC 

SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USERSERVICEABLE PARTS INSIDE. REFER 
SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an 
equilateral triangle, is intended to alert the user to the 
presence of uninsulated “dangerous voltage” within the 
product’s enclosure that may be of sufficient magnitude to 
constitute a risk of electric shock to persons.

„

„

IMPORTANT SAFETY INSTRUCTIONS

1)  Read these instructions.
2)  Keep these instructions.
3)  Heed all warnings.
4)  Follow all instructions.
5)  Do not use this apparatus near water.
6)  Clean only with dry cloth.
7)  Do not block any ventilation openings. Install in accordance with the 

manufacturer’s instructions.

8)  Do not install near any heat sources such as radiators, heat registers, stoves, 

or other apparatus (including amplifiers) that produce heat.

9)  Do not defeat the safety purpose of the polarized or grounding-type plug. A 

polarized plug has two blades with one wider than the other. A grounding 
type plug has two blades and a third grounding prong. The wide blade or 
the third prong are provided for your safety. If the provided plug does not 
fit into your outlet, consult an electrician for replacement of the obsolete 
outlet.

10)  Protect the power cord from being walked on or pinched particularly at 

plugs, convenience receptacles, and the point where they exit from the 
apparatus.

11)  Only use the power cable/AC adapter/attachments/accessories specified by 

the manufacturer.

12)  Use only with the cart, stand, tripod, bracket, or 

table specified by the manufacturer, or sold with the 
apparatus. When a cart is used, use caution when 
moving the cart/apparatus combination to avoid 
injury from tipover.

13)  Unplug this apparatus during lightning storms or 

when unused for long periods of time.

14)  Refer all servicing to qualified service personnel. 

Servicing is required when the apparatus has been damaged in any way, 
such as power supply cord or plug is damaged, liquid has been spilled or 
objects have fallen into the apparatus, the apparatus has been exposed to 
rain or moisture, does not operate normally, or has been dropped.

15)  The apparatus shall be used in an open area.
16)  Apparatus shall not be exposed to dripping or splashing and that no 

objects filled with liquids, such as vases, shall be placed on apparatus.

17)  Mains plug is used as disconnect device. It shall remain readily operable and 

should not be obstructed during intended use. To completely disconnect 
the apparatus from supply mains, the main plug of the apparatus shall be 
disconnected from the mains socket outlet completely.

„

„

FCC (U.S.A.) & ICES-003 (Canada) INFORMATION

1. IMPORTANT NOTICE

  This product, when installed as indicated in the instructions contained in this 

manual, meets FCC and ICES-003 requirements. Changes or modifications not 

expressly approved by Fostex Company for compliance could void the user’ s 

authority to operate the equipment. DO NOT MODIFY THIS PRODUCT.

2. IMPORTANT

  In order to comply with FCC and ICES-003 requirements, use high quality 

shielded cables for connection to accessories and / or another products. If 

any cables are supplied with this product, they MUST be used. Follow all 

installation instructions. Failure to do so could void your FCC / ICES-003 

authorization to use this product in the USA / Canada.

3. NOTE

  This equipment has been tested and found to comply with the limits for a 

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in 

a residential installation. This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in accordance with 

instructions, may cause harmful interference to radio communications. 

However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to correct the interference by one or more of 

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

4. Compliance with Part 15 of FCC Rules and Canadian ICES-003.

  This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: (1) This device may not cause harmful interference, 

and (2) this device must accept any interference received, including 

interference that may cause undesired operation.

  This Class B digital apparatus complies with Canadian ICES-003. Cet appareil 

numérique de la classe B est conforme à la norme NMB-003 du Canada.

Содержание PM0.4c









Отзывы: