21
&
Service Manual
4-6. Bus Check
This menu checks if various bus signals connected to the CPU are cor-
rectly working or not.
1) After selecting the “Bus Check” menu, connect the foot SW to the
foot SW jack and the USB cable between the USB and USB HOST
ports.
2) Press the [MENU/ENTER] dial to initiate the Bus Check mode.
•
AUDIO
BUS
The AUDIO BUS setting is
fi
xed at “THRU” in this menu. In the
“THRU” setting, the A/D and D/A converters are internally con-
nected. Also the CHAN A/C and B/D PAN setting are set to left
and right respectively. Thus, the signals fed to CHAN A and C are
summed and output from the STEREO OUT L and the signal fed to
CHAN B and D are summed and output from the STEREO OUT R.
This mode is convenient when checking the input circuit.
•
ATA
BUS
The “OK” sign indicates that the ATA bus communication between the internal HD and the CPU is properly
made. If the “NG” sign appears, something must be wrong with the ATA bus communication.
•
INPUT
SEL
The “INPUT SEL” indicates the number corresponding to the INPUT A SELECT switch setting as follow.
GTR
CLEAR:
2
GTR
DISTORTION:
1
MIC/LINE:
3
•
FOOT
SW
When an unlatched type foot switch is connected and it is pressed,
the “ON” indication will appear. If the foot switch is released or is
not connected, the “OFF” sign will appear.
•
USB
BUS
If the “USB BUS” section indicates the “OK” sign 3 ~ 5 seconds
after the “WAIT..” sign is displayed, the USB HOST function works
properly. If the “NG” sign is displayed, press the
[MENU/ENTER]
dial and then try to enter the Bus Check mode again by pressing the [MENU/ENTER] dial.
•
ATAPI
BUS
The “OK” sign indicates that the ATAPI bus communication between the CD-R/RW drive and the CPU is
properly made. If the “NG” sign appears, something must be wrong with the ATAPI bus communication.
USB
USB HOST
MIDI OUT
DIGITAL OUT
FOOT SW
INPUT A SEL
GTR CLEAN
MIC/LINE
GTR DIST
USB cable
Foot SW
(unlatched type)
