48
Model LR16 [Recorder functions / Recording/playback]
The track numbers ("1" through
"16") and "LR" flash.
Recordable
remaining time
Adjusting input level (=recording level) of each
mixer channel
(3)
Press the [RECORD] key.
The key lights up and the level meters 1
through 16 on the display now show the
recorder input levels (= mixer channel
levels).
<Memo>:
See pages 82 and 83 for de-
tails about how to change settings of Fs/
bit and MTC frame rate.
(1)
Select Fs/bit of the project and MTC frame rate.
By default, Fs/bit is set to "44.1kHz/16 bit"
while MTC frame rate is set to "25fps".
You can change them before recording.
(2)
Set all the [REC TRACK SELECT] keys (1
through 16) and the [ST MIX] key in the
recorder section to ON.
All the keys start flashing. On the display,
track numbers "1" through "16" and "LR"
start flashing, while the recordable
remaining time is shown.
Preparation
The following shows the procedure for rehears-
ing recording to tracks 1 through 16 as well as
to the stereo mix track simultaneously in new
project mode during live performance.
In the following description, it is assumed that
no project is created to the internal hard disk
("No project" is shown on the display).
(1)
Set the [SOURCE] switch on each of mixer
channels 1 through 16 to "INPUT" (
).
The input source from the corresponding
[INPUT] connector is selected as the
channel source of each channel.
(4)
Use the [TRIM] control each of mixer
channels 1 through 16 to adjust the input
level.
Adjust the [TRIM] control appropriately so
that the [PEAK] indicator is lit at the
loudest part of playing.
<Note>:
The recording level of each track
is equal to the mixer channel level ad-
justed by the [TRIM] control. Therefore,
levels shown on the display can be re-
garded as recording levels as well as mixer
channel levels.
Recorder input levels are shown.
ON (
)
Flashing
Flashing
<Memo>:
If you want to adjust the input
level of each mixer channel while moni-
toring, set the [SOLO] switch on the de-
sired channel(s) to "ON" (
).
When any [SOLO] switch is "ON", the
[SOLO] indicator in the MONITOR SELECT
section flashes slowly.
<Memo>:
To perform recording to an existing
project, use the insert mode (see page 65 for
details about how to create a new project).
<Memo>:
To record only tracks 1 through
16, set only the [REC TRACK SELECT] keys
1 through 16 to ON. To record only the
stereo mix track, set only the [ST MIX] key
to ON.
(2)
Change the destination channels of Sub In
from “15/16” (default) to “-/-” (no channels are
assigned).
You can now record to all of tracks 1 through
16.
<Memo>:
See page 79 for details about
how to assign the destination channels
of Sub In.
Содержание LIVE RECORDING MIXER LR16
