Foster MILANO GRAND CHEF 2460 900, Руководство по установке

Страница: 9 / 24

WORKING
The functions of the keys of the Touch
Control keypad (push button control pa-
nel) are described below:
A: LIGHT SWITCH ON/OFF
B: SPEED REDUCTION / OFF MOTOR
C: SPEED INDICATORS D: ON MOTOR /
SPEED INCREASE E: TIMER 10 min.
OPERATING PROCEDURES
WOR$ING
The functions of the keys of the Touch Control keypad ( push button control
panel ) are described below:
A: LIGHT SWITCH ON/OFF
B: SPEED REDUCTION / OFF MOTOR
C: SPEED INDICATORS
D: ON MOTOR / SPEED INCREASE
E: TIMER 10 min.
For the Touch Control “ROSSO” (RED) version, it is possible to set the shut off
of the lighting function of the keypad by pressing the light key (A) for
6 seconds
(this operation must be done with both lights and motor switched off). This
function permits for the automatic shutoff of the keypad after 10 seconds from
shutoff of the lights and the motor. To re-activate the keypad it is sufficient to set
a function.
To keep the lighting of the keypad always on, press the light key for
6 seconds
(this operation must be done with both light and motor switched off).
MAINTENANCE
Careful and accurate maintenance guarantees good functioning and long lasting
performance.
Particular care must be taken for the grease filter panel
The removal of the metal grease-filter is done by pushing the special filter handle
towards the rear side of the cooker hood, making it rotate downwards. (fig.3).
The filter is inserted by inversely repeating this operation.
After 30 hours of cooker hood functioning, the keypad will signal the filter
saturation , by the flashing of the speed indicators.
In order to reset, please press the timer key.
The grease filter may be washed by hand or in the dishwasher. How often it is
cleaned depends on usage, however, generally at least once every two months.
Tepid water and a mild detergent are recommended for cleaning the appliance; the
use of abrasive products should be avoided.
To clean steel appliances the use of special products is recommended, while
carefully following the instructions shown on the product itself.
To replace the dichroic lamp, remove the lamp by inserting a small screwdriver (or
any sharp utensil) between the lamp and the steel and replace it with a lamp of the
same kind.
The supply cord should be replaced by qualified and authorized personnel only.
For the Touch Control version, it is pos-
sible to set the shut off of the lighting
function of the keypad by pressing the
light key (A) for 6 seconds (this operation
must be done with both lights and motor
switched off). This function permits for
the automatic shutoff of the keypad after
10 seconds from shutoff of the lights and
the motor. To re-activate the keypad it is
sufficient to set a function. To keep the
lighting of the keypad always on, press
the light key for 6 seconds (this operation
must be done with both light and motor
switched off).
In the case of the sucking version, con-
nect the flange of the cooker hood to the
air outlet hole, which is already prepared,
through a suitable pipe. Position the two
chimneys on the cooker hood in their pro-
per seat, raising the upper chimney to the
desired height and fix the appropriate be-
arings using the included screws and rein-
forcements.
After having fixed the hood-bearing stir-
rup of the upper chimney, raise and block
it with the two side screws.
!
!
Di
Di
is.!6!
is.!8!
Dis.!10 0
Di
Dis.!11
is.!9
Diis.!7
!
!
Di
Di
is.!6!
is.!8!
Dis.!10 0
Di
Dis.!11
is.!9
Diis.!7
9