Foster 7014 032, Руководство пользователя

Страница: 33 / 100

33
TECHNICAL INFORMATION
FOR THE INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer (law n° 46 and D.P.R. 447).
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or
by his duly authorized dealer.
3) INSTALLING THE HOB
Check that the appliance is in a good condition
after having removed the outer packaging and
internal wrappings from around the various loose
parts. In case of doubt, do not use the appliance
and contact qualified personnel.
Never leave the packaging materials
(cardboard, bags, polystyrene foam, nails, etc.)
within children’s reach since they could
become potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the cooktop
will be installed are indicated in either fig. 9.
Always comply with the measurements given for
the hole into which the appliance will be recessed
(see fig. 9 and 9/A).
The prospective walls (left or right) that exceed the
working table in height must be at a minimum
distance from the cutting as mentionned both in
the columns “E” of the scheme.
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
4) FITTING THE HOB
T The cooktop has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this seal:
- take off all the movable parts of the hob.
- Detach the seals from their backing, checking
that the transparent protection still adheres to the
seal itself.
- Overturn the cooktop and correctly position seal
“E” (fig. 10) under the edge of the cooktop itself,
so that the outer side of the seal perfectly
matches the outer perimetral edge of the
cooktop. The ends of the strips must fit together
without overlapping.
- Evenly and securely fix the seal to the cooktop,
pressing into place with the fingers and remove
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
- Fix the hob with the proper brackets “S” and fit
the prominent part into the porthole “H” on the
bottom; turn the screw “F” until the bracket “S”
stick on the top (fig. 10/A).
- Carefully trim the edge excess putty with a tool
(fig. 10/B ).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the working,
is necessary to put a wooden insert, fixed by
screws, at a minimum distance of 70 mm from the
top (see fig. 9).
IMPORTANT!
A perfect installation, adjustment or
transformation of the cook top to use
other gases requires a QUALIFIED
INSTALLER: a failure to follow this rule
will void the warranty.
INSTALLATION