Foss NIRS DA1650, Руководство пользователя, Страница: 56 / 72

NIRS™ DA1650
4:26 User Manual 6008 1286 / Rev. 8
4. Press Start and enter pin code “1234” to run the check sample definition.
Fig. 4:43
5. The check sample will now go through a series of analysis. ISIscan Nova may
ask you for a Sample number (depending on settings in Operation profile. A
Sample number is not required, but if you have more than one check sample it
could be wise to enter the Serial number of the check sample in this field for
future reference.
6. Result for the check sample definition is displayed after analysis and this target
is stored in ISIscan Nova as the target value for the check sample test.
Running a Check Sample test (ISIscan Nova)
1. Select the check sample product (box to the right should not be ticked)
Fig. 4:44
2. Place the check sample in the instrument using the small cup holder.
3. Close the lid.
4. Press
Start to analyse the check sample. The check sample will now go through
a series of analysis. ISIscan Nova may ask you for a Sample number (depending
on settings in Operation profile. A Sample number is not required, but if you
have more than one check sample it could be wise to enter the Serial number of
the check sample in this field for future reference.
5. Result for the check sample test is displayed after analysis.
If the check sample test fails the results are displayed in yellow or red colours
depending on whether the results are outside warning- or error limits. Please check
that the correct check sample was used and that the glass surfaces on the check
sample cup and the instrument are clean. Run the check sample test again to verify if
results are still outside limits.
Samples can still be analyzed even after a failed check sample but they will be high-
lighted as Warning (in yellow) to indicate that last check sample was not OK.
Please consult your local standard operating procedures how to act on a failed check
sample.