IV5016
-
E Issue J
Page 7 of 7
Foss AS
P.O. Box 3614
N
-
3007 Drammen
Tel47 32 21 08 00
T47 32 21 08 08
firmapost@foss
-
as.no
www.fossfibreoptics.com
The information in this document is believed to be reliable (including drawings and pictures). However, FOSS AS makes no warranties as to its
accuracy or completeness and disclaims any liability in connection with its use. The document may contain inaccuracies and errors. In no case
will FOSS AS be liable for any incidental, indirect or consequential damages arising out of the sale, resale, use or misuse of the described
products. Users of FOSS AS products should make their own evaluation to determine the suitability of each such product for the specific
application. In no case will FOSS AS be liable for any errors, inaccuracies, omissions or lack of validity of information in this document.
Any use or copying of this document for other purposes than it is intended is strictly forbidden.
Prepare the cable(s) as shown in drawing 5.1.
Connectors for direct termination (e.g. FAST, UniCam, FuseConnect) are
assembled according to the instructions from the supplier.
Then follow the instructions in chapter 4, figure 4.1 and onwards.
Prepare the cable(s) as shown in drawing 6.1.
Make sure every fibre is cleaned and that all grease is removed.
Connectors for direct termination (e.g. FAST, UniCam, FuseConnect) are
assembled according to the instructions from the supplier.
Then follow the instructions in chapter 6A, figure 6.2 but do
NOT
install the
splice holder.
The adapter plate may be lifted up and turned to give easier access to the
adapters on the inside. See ch. 4.3.
Clean the adapters. Distribute the fibres on the guiding crosses according to
the adapters they shall be mounted in. Clean the connectors and insert them
in the adapters.
Close the fibre guides
(see picture 3.2.1).
7.2 Finished panel
7. Installing direct terminated cable
Direct termination may be used on several cable types. In the following cable with tight buffered fibre and loos tube cable are covered.
7.1 Finished panel
7A. Cable with tight buffered fibre
7B. Cable with loose tube
7.1 Finished panel
