FOS Technologies 12R Hybrid PRO, Руководство пользователя, Страница: 4 / 16

280W BEAM SPOT WASH 3-IN-1 MOVING HEAD
Page 2

Frost filter for wash

0-100% mechanical dimming, mechanical dimming and free dimming available.

strobe macro control available.

Beam angle: 3.8°-20°

Over heat protection

Power Input: 100-240V
，
50/60Hz

Power consumption
：
400W

IP rating :IP20 for indoor use only

Magnetic ballast and AC/Dc power supply
5. Cable connection
（
DMX
）
Use a cable conforming to specifications EIA RS-485: 2-pole twisted, shielded, 120Ohm characteristic
impedance, 22-24AWG,low capacity. Do not use microphone cable or other cable withcharacteristics differing
from those specified. The end connections must be made using XLRtype3 or 5-pin male/female connectors. A
terminating plugmust be inserted intothe lastprojector witha resistance of 120Ohm (minimum 1/4 W) between
terminals 2 and3.
IMPORTANT: Thewiresmustnotmakecontact witheachotheror withthemetalcasing of theconnectors.
The casing itself must be connected to the shield braid and to pin 1 of the
connectors.
Figure 1 DMX Cable connection
6. Rigging (Optional)
This equipment can be positioned and fixed by clamp in every direction of the stage. Locking
system makes it easy to fasten to the bracket.
Attention! Two clamps is needed to fix the equipment. Every clamp is locked by fastener of 1/4
kind. Fastener can only be locked clockwise.
Attention! Fasten a safety string to the additional hole of side aluminum piece. The secondary
accessory can not hang on the delivery handle. Nip the equipment on bracket.

Check if rigging clamp (not including the one inside) damaged or not? If stand ten times
weight as the equipment. Make sure the architecture can stand ten times weight as all the
equipments, clamps, wiring and other additional fixtures.
DMX Out
DMX512
3 PIN
SIGNAL
SIGNAL
SCREEN
1
2
3