Forza FDC-2012R-I, Руководство пользователя

Страница: 3 / 13

- Use only tools with insulated grips and handles.
- Wear rubber gloves and boots.
- Do not lay tools or metal parts on top of batteries.
- Disconnect charging source prior to connecting or disconnecting battery terminals.
- Determine if battery is inadvertently grounded. If inadvertently grounded, remove source from ground. Contact with any part of a
grounded battery can result in electrical shock. The likelihood of such shock can be reduced if such grounds are removed during
installation and maintenance.
• When replacing the battery, make sure to use the same type and number of sealed lead-acid batteries specified.
• Do not dispose of batteries in a fire. Batteries may explode if exposed to high temperatures.
• Never try to open a battery. The cell contains a toxic electrolyte which is harmful to the skin and eyes.
• Replace the fuse only with the same type and amperage in order to avoid fire hazards.
• Do not dismantle the UPS system.
2. OPERATION
2-1. Unpacking and inspection
Remove the UPS from its package and make sure that all the following items are included:
• One UPS unit
• One monitoring software CD (ForzaTracker)
• One USB cable
• One 16A IEC C19 to 5-15P
• One 16A IEC C19 to CEI 23-50
• One 16A C19 to IRAM 20736
• Two C14 to 5-15R cables
• Rack mounting hardware
• Tower support base
• One user manual
• Warranty certificate
Carefully inspect the UPS to check for any damages that may have occurred during shipping.
Should any evidence of damage be found or if some parts are missing, do not turn the UPS on; you must immediately notify the carrier
or dealer where you purchased the unit.
2-2. UPS diagram
Front view Rear view
FDC -2012R-I
FDC -3012R-I
1. Programmable outlets for non-critical loads
2. Dedicated outlets for critical loads
3. AC input
4. Modem/phone/network surge protection
5. USB communication port
6. RS-232 communication port
7. SNMP intelligent slot
8. Emergency Power off connector (EPO)
9. External battery connection
10. Cooling fan(s)
2.3. Installation procedure
Choose location
Install the UPS unit in any protected environment that provides adequate airflow around the unit, and free from excessive dust, corrosi-
ve fumes and conductive contaminants. Do not operate your UPS in an environment where ambient temperature or humidity is high.
For best performance, keep the indoor temperature between 0° C and 45° C. Place the UPS unit at least 20cm away from monitors to
avoid interference.
2.3.1 Initial setup
• For safety considerations, the UPS is shipped out from the factory with battery wires disconnected.
• Before installing the UPS, the user must first reconnect the wires. To do so, follow the steps illustrated below.
This UPS can be either placed on a desktop, mounted in a rack or installed in an upright position. Define the proper display orientation
based on the configuration chosen to install this UPS.
Rack-mount installation
The unit comes with mounting brackets for the standard 19-inch (46.5cm) rack.
Step 1
Remove the front panel.
Step 2
Connect the AC input and then
reconnect battery wires.
Step 3
Replace the front panel.
Step 1 Step 2