1-5. Maintenance, service and faults
Rear panel view
2.3. Installation procedure
Choose location
2. OPERATION
2-1. Unpacking and inspection
1.
2.
3.
4.
5.
6.
• One UPS unit
• One user manual
• One monitoring software CD (ForzaTracker)
• One USB cable
• Warranty certificate
Install the UPS unit in any protected environment that provides adequate airflow around the unit, and free from excessive
dust, corrosive fumes and conductive contaminants. Do not operate your UPS in an environment where the ambient
temperature or humidity is high. For best performance, keep the indoor temperature between 0° C and 40° C. Place the
UPS unit at least 20 cm away from monitors to avoid interference.
AC input
Input circuit breaker
USB communication port
RS-232 communication port
SNMP intelligent slot (optional)
Output receptacles
Remove the UPS from its package and make sure that all the following items are included:
•
•
•
•
•
•
•
•
•
•
The voltage used by this UPS may be hazardous. The unit contains no user serviceable parts; do not attempt to
disassemble the unit. Only qualified service technicians can perform maintenance on the unit. Failure to adhere to this
could cause personal injury or equipment malfunction and void the warranty.
Caution
- risk of electric shock. Even after the unit is disconnected from the mains, components inside the UPS system
are still connected to the battery packs which are potentially dangerous.
Before carrying out any kind of service and/or maintenance, disconnect the batteries and verify that no current is
present and no hazardous voltage exists in the terminals of high capacity capacitors, such as BUS-capacitors. Servicing
of batteries should be performed or supervised by experts who possess the knowledge to closely follow all required
precautions.
Caution
: potentially hazardous voltages from the battery can still be present even after disconnecting the UPS from the
AC mains. Therefore, the positive and negative terminals of the battery shall de disconnected prior to performing any
maintenance or repair inside the unit.
A battery can present the risk of short-circuit current and electrical shock. The following precautions should be taken:
- remove wristwatches, rings and other metal objects
- use only tools with insulated grips and handles.
When replacing the battery, make sure to use the same type and number of sealed lead-acid batteries specified.
Do not dispose of batteries in a fire. Batteries may explode if exposed to high temperatures.
Never try to open a battery. The cell contains a toxic electrolyte which is harmful to the skin and eyes.
Replace the fuse only with the same type and amperage in order to avoid fire hazards.
Do not dismantle the UPS system.
2-2. UPS diagram
Front panel view
Carefully inspect the UPS to check for any damages that may have occurred during shipping.
Should any evidence of damage be found or if some parts
are missing, do not turn the UPS on; you must immediately
notify the carrier or dealer where you purchased the unit.
2-4. UPS connections
2-4.1 UPS input connection
Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords or adapter plugs.
2-4.2 UPS output connection
• For socket-type outputs, simply connect devices to the outlets.
FDC-1002T
FDC-1000T
FDC-2002T
FDC-2000T
Содержание FDC-1000T
Страница 1: ...2 Y e a r W a r r a n t y...
Страница 5: ...3 2 LCD panel 3 3 Audible alarm...
