Add the Default Administrator User Name and Password
********************************************************
* Management User Policy *
* *
* The following settings allow you to enter a user *
* policy that can be used to gain access to other *
* user interfaces such as the Web Administration UI. *
********************************************************
Note:
User names must be unique, are case sensitive, and may be from 1 to 80 alphanumeric characters. The ‘@’ character,
underscores, dashes and spaces are allowed; however, no leading or trailing spaces are allowed. User passwords must be unique,
are case sensitive, may be from 6 to 255 alphanumeric characters, and may be any keyboard characters.
#Please enter: User name
#A unique user name
>
admin1
#Please enter: New Password
#The new user password
>
******
#Please enter: Confirm password
#confirm the new user password
>
******
Installation Wizard is now complete!
Type ? for a list of commands
ForumOS>
Record this new password for your convenience. At this point, you are connected to the product in Command mode and have completed
the Installation Wizard.
Troubleshoot the Management Device Interface Filter
The management device interface filter is used to prevent allow management traffic between the data network and management network
for security purposes.
If the MANAGEMENT interface and WAN interface are configured to be on same subnet, you must turn this filter off. From the CLI, enter
the
network config mgmt-filter
command. Enter
N
to turn the filter off.
Troubleshoot Routing Information for the Product
The system supports both Interface routes as well as Gateway routes. When there is no default gateway configured on the product and
you want to set up your routes, enter the
route network add
command from the CLI. For example, for the MANAGEMENT interface to
see the 10.5.2.0 network, use the following CLI command (shown with defined syntactical elements):
<Network IP Address> <Netmask> <Route Type> <Gateway Address>
1=Gateway
2=Interface>
route network add 10.5.2.0 255.255.255.0 1 10.5.3.1
Note:
For more information on the
route network add
command, refer to the
Forum Systems Sentry™ Command Line Interface
Reference
.
The CLI has displayed its start-up screen in the HyperTerminal window and the Forum Systems Installation Wizard has appears. Follow
the Installation Wizard’s prompts.
The Forum Systems Installation Wizard allows you to cycle through a one-time wizard and prompts you to enter critical data in the proper
sequence, including the default Administrator user name and password. If you skip prompts or exit the wizard before configuration is
complete, the product will refresh, and re-display the wizard until all required data has been entered.