16
FENCING INSTALLATION: VERSAI
Step 2:
Pre-Drill and Install Brackets
Tip:
• It’s important to double check dimensions to confirm
accuracy of bracket hole locations before drilling.
1. Use Spring Punch to mark the holes. As shown in Fig. 1.
2. Pre-drill bracket holes with a 5/32” [4mm] drill bit.
As shown in Fig. 2.
3. Attach bracket to the posts with supplied Hex Head
Self-drilling screws. 10mm Nut Driver or T-25 Bit can
be used to install screws. Use low speed setting on
drill.
DO NOT over tighten screws. As shown in Fig. 3.
Fig. 1
Fig. 2
PANEL CUTTING
Step 1:
Measure The Panel Opening Length
1. Measure the distance of the panel opening. As shown in
Fig. 1.
Fig. 3
