FENCING INSTALLATION: VERSAI
11
BRACKET INSTALLATION
Bracket Details:
*Reference Bracket & Rail Options on page 5.
• End Bracket (EX-104) - This bracket can be used in all
applications for Versai Fence. The bracket mounts on the
inside face of the post.
• Swivel Bracket (EXS-104) - This bracket is designed to be
utilized for angled panel installation. The bracket mounts
on the inside face of the post. Maximum angle is 30o.
• Line Bracket (EXW-204) - Utilizing this bracket is one of the
easiest ways of installing the Versai Fence. Once the post is
installed in concrete and set, install an EXW-204 Bracket on
each end of a panel with the bracket centered in the post
of the bracket. Lightly tighten the Bracket Bolt/Nut to hold
the panel in place. Complete this step for each of the rails
on the panel. After all panels have been installed using this
method, return to your starting point. Using a 2” X 4” X 72”
[50mm x 101mm x 1829mm] as a lever, insert the
board under the bottom of the picket closest to the post
and gently pry up on the picket. This will adjust the height
of the panel to the needed height. With the pry board
in place and the panel height set, tighten the Bracket
Bolt/Nut. Once all panels have been leveled and fasteners
tightened, using the 10mm Nut Driver, install the
Self-Tapping Screws into the designated holes on each side
of the bracket.
Note:
DO NOT over tighten the Bracket Bolt/Nut or the
Self-Tapping Screw.
• Corner Bracket (EXW-304) - This bracket was designed to
be used for Corner Post Installation.
