Air flow direction control
Adjust the air flow direction properly. Otherwise
it
might cause discomfort or cause uneven room
temperatures.
Adjust the horizontal/vertical louver using the remote
control.
To set the horizontal/vertical air flow direction
Perform this function while the unit is in operation.
Use the remote control to adjust the air flow direction.
The vertical/horizontal louver changes approximately 6
degree in angle for each press, the louver can also be set
to swing up, down, left and right automatically.
Please refer to the
Remote Control User Manual
for details.
IMPORTANT
: Do not put your fingers into the panel of
blower and suction side.
The high-speed fan inside may
cause danger.
Do not operate the air conditioner for long periods with
the air flow direction set downward in COOL or DRY
mode. Otherwise, condensation may occur on the
surface of the horizontal louver causing moisture to
drop on to the floor or on furnishings.
When the air conditioner is switched on immediately
after it was stopped, the horizontal louver might not
move for approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually. Otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug the power for a few seconds, and
restart the air conditioner.
Do not operate the unit with the horizontal louver in
closed position.
CAUTION
(Horizontal louver)
Range
Range
(Vertical louver)
How the air conditioner works
1 hour
1 hour
Set
Temperature
Set
Temperature
Cooling
Heating
SLEEP operation
1 hour 1 hour
SLEEP operation
7 hours timer off
7 hours timer off
AUTO mode
When you set the air conditioner in AUTO mode, it will
automatically select cooling, heating or fan mode
operation depending on the temperature you have
selected and the room temperature.
The air conditioner will control room temperature
automatically around the temperature point set by you.
If the AUTO mode is uncomfortable, you can set
desired temperature manually.
SLEEP mode
When you press SLEEP button on the remote control
during cooling, heating or AUTO operation , the air
conditioner will automatically increase (cooling) or
decrease (heating) per hour for the first 2 hours, then
hold steadily for the next 5 hours, and switch off
afterwards.
This mode saves energy and brings comfort at night.
DRY mode
The fan speed will be automatically controlled under the
dry mode.
During the dry mode, if the room temperature is
O
lower than 10 C, the compressor will stop operation
and restart until the room temperature is above
O
12 C.
5 hours
5 hours
7
7
8
8
