Fortis FST1WLKPADA, Руководство пользователя

Страница: 15 / 20

How to adjust the running belt?
1. Adjust the screw on the left side of the belt by Allen Key, turning 1/4 times clockwise
to adjust the rear roller to tight the belt.
2. Repeat step 1 to adjust the right screw. Check that the left and the right screw are
adjusted to the same distance so that the rear roller can be paralleled to the
treadmill frame.
3. Repeat steps 1 and 2 until the running belt does not slip.
4. Note: The running belt can't be adjusted too tightly, which will break the running
belt and increase the pressure of the front and rear rollers, causing problems such
as roller bearing damage and abnormal noise. If you want to reduce the tension of
the running belt, turn the wrench counter clockwise. Note that the left and right
sides are rotated at the same distance.
Adjust the running belt to the middle position
When using the treadmill, the pressure on the running belt is unbalanced because the two
feet exert different forces when running, that causes the belt deviate from the centre. This
deviation is normal. When no one is using the treadmill, the belt goes back to the centre
automatically. If not, you need to adjust it to the centre.
How to adjust the running belt to the middle?
1. Run the treadmill with no-load at a speed of 6km/h.
2. Observe the distance of the running belt to the left and right border. If the running
belt deviates to the left side, turn the left screw clockwise for 1/4 by inner hexagonal
wrench. If the running belt deviates to the right side, turn the right screw clockwise
for 1/4 by inner hexagonal wrench. If the running belt is still not in the centre, repeat
the above the step until it is adjusted to the centre.
3. After adjusting the running belt to the centre, adjust the speed to 1km/h and
observe the deviation of the running belt and check whether there is slipping during
running. If still there is any deviation from the centre, repeat the above steps.
4. Warning! Do not over tighten the roller! This will cause the bearing permanent
damage! If the above steps do not work, you need to tighten the running belt
again.