Fortis FSRCMBIK2XA, Руководство пользователя

Страница: 5 / 16

21 Sensor wire 1 50 Seat 1
22 Extension wire 1 51 Tube plug 2
23L/R Protective guard 1/1 52 Foam 2
24 Cross pan bolt ST4.2 × 18 5 53 End cap 2
25a/b Computer protective guard 1 pair 54 Seat cushion 1
26 Hex bolt M8 × 90 2 55 Hex bolt M8 × 12 4
27 Lifting handle 1 56 Backrest 1
28 Tension controller wire 1 57 End cap 2
29 Tension controller 1 58 Cross pan bolt 4
Note: Most of the listed assembly hardware has been packaged seperately, but some
hardware items have been preinstalled in the identified assembly parts. In these instances,
simply remove and reinstall the hardware as assembly is required.
Please refer to the individual assembly steps and make note of all preinstalled hardware.
Preparation: Before assembling, make sure that you have enough space around the
equipment. Use the present tooling for assembly. Before commencing assembly, please
check that all required parts are available.
It is strongly recommended that this unit is assembled by two or more people to avoid
possible injury.
Assembly Steps
Step One
Lock the lifting handle (27) to the rear stabilizer (3)
with the Hex Bolt (26) and an Arc Washer (20).
Attach the front stabilizer (2) and rear stabilizer (3)
to the main frame (1) with a hex bolt (13), spring
washer (14) and arc washer (15).
Step Two
Pull out the tension control wire (28) from the
hole in the handlebar post (4), then install the
tension control wire (28) to the tension
controller (29). Ensure the cable has been
connected correctly as shown. Finally lock the
tension controller (29) to the handlebar post
(4) with the cross pan bolt (31) and the arc
washer (30).
Connect the sensor wire (21), extension wire 1
(36) with the extension wire (22), Extension
wire 2 (37), then lock the handlebar post (4)
to the main frame (1) with the hex bolt (19),
spring washer (14) and flat washer (7). Finally
lock the protective guard (23L/R) to the main frame (1) with the cross pan bolt (24).
4