Fortinet FortiGate-5001D, Руководство пользователя

Страница: 14 / 38

Changing FortiGate-5001D SW6 switch settings Hardware installation
FortiGate-5001D Security System Guide
14
01-500-0242101-20151109
http://docs.fortinet.com/
1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2 Remove the caps from the cage sockets on the FortiGate-5001D front panel.
3 Hold the sides of the transceiver and slide it into the cage socket until it clicks into
place.
Changing FortiGate-5001D SW6 switch settings
The SW6 switch on the FortiGate-5001D board can be set to operate the
FortiGate-5001D in standalone mode (without a shelf manager) or in normal mode in a
chassis with a shelf manager. The switch is factory set by Fortinet so that you can install
the FortiGate-5001D in normal mode in a chassis that includes an operating shelf manger
(such as a FortiGate-5000 series chassis).
The top of the FortiGate-5001D board is covered with a metal panel. The printed circuit
board is under the metal panel. SW6 is located on the printed circuit board and is
accessible from the left side of the board under the metal panel as shown in
Figure 3 .
Figure 3: Location of SW6 on the FortiGate-5001D board
Handling the QSFP+, SFP+ and SFP transceivers by holding the release latch can
damage the connector. Do not force transceivers into their cage slots. If the transceiver
does not easily slide in and click into place, it may not be aligned correctly. If this
happens, remove the transceiver, realign it and slide it in again.
You should only change the SW6 switch setting if are required to install the
FortiGate-5001D board in a chassis that does not contain a functioning shelf manager.
The factory default SW6 setting is required for most uses of the FortiGate-5001D.
FortiGate-5001D
Front Faceplate
Normal Mode
(Factory Default)
ON
S W
34
2
1
ON
S W6
34
2
1
ON
S W6
34
2
1
S tandalone Mode
(No S helf Manager)
Location of S W6