Fortinet FortiAP 112B, Быстрый старт

Страница: 9 / 24

Page 6
2. Telnet to IP address 192.168.1.2.
3. Type
admin
in the Name fi eld, leave the Password fi eld blank,
and press
Enter
.
4. Enter the following to enable Mesh mode and set the SSID and
password:
cfg -a MESH_AP_TYPE=1
cfg -a MESH_AP_SSID=fortinet.mesh.root
cfg -a MESH_AP_PASSWD=fortinet.mest.root
It is recommended that you change both the default SSID and
password.
5. Optionally, enable the Ethernet bridge for building to building
bridging with the following command:
cfg -a MESH_ETH_BRIDGE=1
6. Check the values using the following command:
cfg -s
The output should be similar to the following:
MESH_AP_TYPE:=1
MESH_AP_SSID:=fortinet.mesh.root
MESH_AP_BSSID:=
MESH_AP_PASSWD:=*******
MESH_ETH_BRIDGE:=1
7.
Save the confi guration as follows:
cfg -c
8. Disconnect the FortiAP device.
9. Aim the front of the FortiAP unit towards the upstream mesh
node (usually another AP device) to complete the association.
Once the link is established, the Mesh signal intensity indicators
should change from fl ashing to red, yellow, or green. If red,
adjust the location of the unit and the direction it is facing until
the intensity indicators show yellow or green.
Note: The FortiAP 112B has a directional antenna located on the front
of the device. The device must be aimed towards a mesh node to
achieve a connection. See
Mounting Your FortiAP Unit on page 7 .
LAN
PoE
LAN
Port
ETH
Port ETH (PoE)
Port
PoE
Port
LAN