Fortinet FortiAP 112B, Быстрый старт

Страница: 15 / 24

Page 12
Cautions and Warnings
Please review the following cautions and warnings.
Environmental specifications
Operating temperature: Refer to the product datasheet
If you install your Fortinet product in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than
room ambient temperature. Therefore, make sure to install the equipment in
an environment compatible with the manufacturer’s maximum rated ambient
temperature.
Storage temperature: Refer to the product datasheet
Humidity: Refer to the product datasheet
Air flow - For rack installation, make sure that the amount of air flow required for
safe operation of the equipment is not compromised.
For free-standing installation, make sure that the appliance has at least 1.5 in.
(3.75 cm) of clearance on each side to allow for adequate air flow and cooling.
FCC Compliance
The Fortinet product has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this
equipment.
For operation within 5.15 ~ 5.25GHz frequency range, this device is restricted to
indoor environments.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
IMPORTANT NOTE: Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for
uncontrolled environments. This equipment should be installed and operated
with a minimum distance of 21cm between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter. The availability of some specific channels and/
or operational frequency bands are country dependent and are firmware
programmed at the factory to match the intended destination. The firmware
setting is not accessible by the end user.