Note:
The alarm system is not active (including Starter Kill) when the system is in Valet Mode. However you are still
able to lock and unlock the doors, and release the rear hatch/trunk.
Note:
When the Remote-Starter/Alarm is in Valet Mode, the LED will stay ON solid instead of flashing after the
doors are locked. The LED will turn off only after the Remote-Starter/Alarm exit Valet Mode.
The valet mode can be programmed to use a coded entry in order to increase the security of your alarm system and
to prevent accidents. By default, the valet button is pressed 3 times after turning the ignition. Function 30 can be
programmed to use a coded value instead of the default one.
VALET CODING DISBALED (DEFAULT):
To activate and deactivate Valet Mode using the valet switch proceed with the following steps:
STEP 1
Insert the key and turn it to the ignition (ON/RUN) position. The vehicle
does not need to be started.
STEP 2
Within 10 seconds press (1 second) and release the Valet switch 3
times.
STEP 3
Valet mode enabled: The LED is ON
Valet mode disabled: The LED is OFF
VALET CODING ENABLED (OPTIONAL):
To activate and deactivate Valet Mode using the valet switch proceed with the following steps:
STEP 1
Insert the key and turn it to the ignition (ON/RUN) position. The vehicle does
not need to be started.
STEP 2
Within 10 seconds press and release the valet button 3 to 7 times (X = valet
code) for 1 second. If your valet code is 7 then press and release the valet
button 7 times.
STEP 3
Press and hold the valet button once for 3 seconds to finish the sequence.
STEP 4
Valet mode enabled:The LED is ON
Valet mode disabled: The LED is OFF
Note: The coded valet option allows a selection of one of the five available codes.
Once the installer chooses one of the codes, note the value here so you do not forget
it_____________________.
VALET MODE (VIA REMOTE)
Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or repaired, or the vehicle
is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental Remote-Start.
Note
: The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode. However you are
still able to lock & unlock the doors, and release the rear hatch/trunk. This method of enabling/disabling Valet Mode
uses the remote transmitter instead of the valet switch indicated in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
+
Simultaneously press the LOCK and UNLOCK buttons for 1 second. The
remote Green Led flash and bip once to confirm. The parking lights will
flash once.
Page 8 / 13
