Fortin ANT900, Руководство пользователя

Страница: 6 / 13

METHOD 1
PROGRAMMED BY DEFAULT THIS METHOD WILL ACTIVATE THE REMOTE CAR STARTER SEQUENCE ONLY WHEN
THE END USER IS USING THE REMOTE CAR STARTER REMOTE:
The vehicle must be running.
STEP 1
and
Make sure that all doors are closed and the transmission is in the
NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4 Press the button for 3 seconds. The remote Green Led turn ON
for 1 second and a ascending melodie will sound to confi rm.
The parking lights will fl ash once and then remain on.
STEP 5
OFF Remove the key from the ignition barrel.
The vehicle will remain running with the Remote-Starter.
STEP 6 Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are
closed.
METHOD 2 This method must be programmed by the installer during installation.
THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE
VEHICLE.
AUTOMATIC ACTIVATION:
The vehicle must be running.
STEP 1
Make sure the transmission is in the NEUTRAL position.
STEP 2
Engage the parking brake.
STEP 3
Release the brake pedal.
STEP 4
OFF Remove the key from the ignition barrel. The engine will shut
down and the vehicle will be ready to start at any time.
STEP 5 Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are
closed.
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from step 1
.
TO DEACTIVATE READY MODE:
•
Open any door(s) • Open the hood • Disengage of the parking brake
Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.
Page 6 / 12