Fortin ANT900, Руководство пользователя

Страница: 4 / 13

•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specifi cation RSS 210. Its use is
authorized only on a no-interference, no-protection basis; in other words, this device must not be
used if it is determined that it causes harmful interferences to services authorized by IC. In addition,
the user of this device must accept any radio interface that may be received, even if this interference
could affect the operation of the device.
Warning! Changes or modifi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate this device.
USING THE REMOTE CONTROL
RM942
COMMANDE
press seconds
COMMAND
TRANSMISSION COMMAND
CONFIRMATION
DESCRIPTION
LOCK
1x
0.5
seconds
Flash Blue
1 beep
Press the button 1x (0.5
seconds) : Locks all
doors, arm the anti-theft
system and activates the
Alarm (if installed).
Green LED ON
for 1 second
UNLOCK
2x
0.5
seconds
Flash Blue
2 beep
Press the button 2x
(0.5 seconds): Unlocks
all doors, disarms the
anti-theft system and
deactivates the Alarm (if
installed).
Green LED ON
for 1 second
START
1x
3
seconds
Flash Blue
ASCENDING
SOUND
Press and hold the but-
ton for 3 seconds: Re-
mote-start the vehicle.
If the engine is OFF : the
engine will turn ON.
Green LED ON
for 1 second
STOP
1x
3
seconds
Flash Blue
DESCENDING
SOUND
Press and hold the but-
ton for 3 seconds: Re-
mote-stop the vehicle.
If the engine is ON : the
engine will turn OFF.
RED LED ON
for 1 second
The remote BLUE led turn ON when a button is pressed.
The remote fl ash BLUE when the remote is transmitting the informations.
The remote GREEN led turn ON when the vehicle succesfully received the command.
After 3 seconds of transmission, if the command failed
[1] the remote RED led turn ON.
NOTE [1]: It is possible that the remote control was able to communicate with the remote-starter and that action was
performed successfully, but the remote-starter was unable to send its response back to the remote control. Some
factors such as radio interference may interfere with the communication between the remote control and the remote-
starter. See the TRANSMITTER RANGE page 11 and FAILED REMOTE-START page 11
Page 4 / 12