10
COLD START TIMER MODE
Cold Start Timer Mode will remote-start the vehicle every 1.5 or 3 hours and run for 3, 5, 7 or 15
minutes (6, 14 or 30 for diesel engines), depending on programming. The remote-starter will repeat
this sequence for up to a maximum of 24 hours. For manual transmission vehicle’s READY MODE
must be enabled, and if at any time READY MODE is disabled this sequence will cancel.
WARNING Do not start the vehicle indoors (garage, underground parking).
To enable Cold Start Timer Mode
Æ
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 5).
To disable Cold Start Timer Mode do any of the following:
•
Æ
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 4).
• Put the Remote-Starter/Security-System into Valet Mode.
• Remote-Start the vehicle.
• Open the hood.
• Press the brake pedal.
• Turn the key to the ignition
(ON / RUN)
position.
• Disable Ready Mode (manual transmission).
Note: If the Alarm is triggered during Remote-Start (Cold Start), the vehicle will stop running, but Cold
Start will not cancel its schedule.
AUXILIARY USE
The function of the auxiliary outputs may vary depending on the vehicle and the installation. In most
cases these outputs are not used, and in some cases they may be used to control other features such
as the sliding door, power windows, sunroof, or heated seats. Check with the installer to find out what
AUX
outputs have been installed, and what they control.
Æ
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 5).
REMOTE STARTING OPTIONS
(WITH OPTION AVAILABLE)
REMOTE DOOR LOCKS
If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without
using the key or OEM key fob.
To
UNLOCK
the doors and
DISARM
the security:
Press the
UNLOCK
button for 1 second.
The parking lights will flash twice and the LED (if installed) will turn OFF to confirm the signal. The
Starter-Kill will also deactivate allowing the vehicle to be started with the key. If
UNLOCK
is pressed
again (consecutively) the horn will honk twice (if installed) to confirm.
Note:
The system can be configured during installation so the horn confirms
UNLOCK
on the first
attempt.
To
LOCK
the doors and
ARM
the security:
Press the
LOCK
button for 1 second.
The parking light will flash once and the LED (if installed) will turn ON to confirm the signal.
