Fortin Electronic Systems FSA-208, Руководство по установке

Страница: 6 / 32

5
Installation Guide
18 PIN MAIN HARNESS
wire
COLOUR FONCTION DESCRIPTION
1 BLACK
(–) Chassis
Ground Input
This wire must be connected to bare,
unpainted, non-corroded metal (on the
vehicle chassis). It is preferable to use a
factory ground bolt rather than a self-tapping
screw. Screws loosen over time which cause
erratic behaviour.
2 GREY
(–) Hood Pin
Input
Zone 5
Connect to the Hood Pin safety switch.
Note: This input should be at ground
whenever the hood is opened to prevent
Remote-Starting.
IMPORTANT! Mandatory on all vehicles.
3
BROWN/
YELLOW
(–) Door Pin
Input
Zone 3
This zone should be used in a vehicle equipped
with a negative door pin circuit. This zone
triggers the alarm.
WARNING ! Ensure this wire is grounded
whenever any door is opened. Only
connecting the drivers door is not sufficient.
4 DK GREEN
(–) Trunk Pin
Input
Zone 6
This zone triggers the alarm.
5 YELLOW
(–) Starter Kill
/Anti-Grind
Output
This wire provides a starter kill signal with
PASSIVE and ACTIVE arming. The wire is
meant to immobilize the vehicle whenever the
Alarm is armed, and provide anti-grind
whenever Remote-Started by providing a
constant negative output (400mA) when the
Alarm is armed or Remote-Started. This wire
is meant to be connected to an external relay.
(See Quick Installation Guide).