Fortin Electronic Systems FSA-208, Руководство по установке

Страница: 3 / 32

Installation Guide
2
INTRODUCTION
This guide contains all the information relevant and necessary for the installation of the
module. Most of the features of this product are explained in the User Guide. Therefore, if
detailed information regarding a feature of the product is needed, refer to the User Guide.
PART LIST
Please carefully read the installation guide before beginning the installation, especially the
harness descriptions and the programming options. It is very important that the
programming and the operation of the module are clearly understood, even with similar
installation experience in the past. There are many innovative features that may be
overlooked if this guide is not read thoroughly. Prior to the installation, make sure that all
the hardware components required to install the system are included in the box.
The following is a list of components included in the kit:
●
1x Remote-Starter control unit
●
1x or 2x Transmitters
●
1x Antenna
●
1x 6 pin primary ignition harness (AWG 14)
●
1x 18 pin secondary harness (AWG 22)
●
1x parts bag: a hood pin-switch, a connector and a warning label
●
1x Valet switch (SPST)
●
1x User guide
●
1x Quick Installation guide
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful
communication.
FCC – USER NOTICE:
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment.
INSTALLATION POINTS TO REMEMBER
•
Make sure that vehicles equipped with an Automatic transmission can not start while in
any gear other than park.
If the vehicle starts in gear, a Manual transmission Remote-
Starter must be installed.
•
When installing a Manual transmission Remote-Starter on a vehicle with a Manual
transmission, always make sure that all doors will take the Remote-Starter out of Ready
Mode. If this is not the case switch the wire(s) so that the module can monitor all doors
(including the rear hatch).
•
When installing a Manual transmission Remote-Starter on a vehicle with a Manual
transmission, ensure that the parking brake and all door switch contacts are working
properly.
•
When working on a vehicle, never leave the keys inside the vehicle and always leave at
least one window open.
•
If possible, remove the courtesy light fuse to prevent battery drain.
•
Before beginning, inspect the vehicle for any body damage or electrical problems.
•
Always solder and tape all connections.
•
Keep the Antenna away from other types of antennas (GPS/OnStar).
•
Never install the module or wiring where it could interfere with the mechanical operation
of the steering and pedals or obstruct service technicians.
•
Always use a grommet when running wires into the engine compartment. Never run
wires near or against bare metal.