Fortin Electronic Systems ANT-FMH-2W, Руководство пользователя

Страница: 9 / 14

VALET MODE (VIA REMOTE)
Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or repaired,
or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental
Remote-Start.
Note : The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode. How-
ever you are still able to lock & unlock the doors, and release the rear hatch/trunk. This method of
enabling/disabling Valet Mode uses the remote transmitter instead of the valet switch indicated in the
preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
+
Press and release the FUNCTION button, within 12 seconds
simultaneously press and hold the LOCK and UNLOCK buttons
for 1 second.
STEP 2
FMH
2-W
The LED will turn ON solid and remain ON.
To exit Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
+
Press and release the FUNCTION button, within 12 seconds
simultaneously press the LOCK and UNLOCK buttons for 1
second.
STEP 2
FMH
2-W
The LED will turn OFF or will start to fl ash.
COLD START TIMER MODE
Mode will remote-start the vehicle when the tempeture is below -5
0
C / 23
0
F every 1.5 or 3 hours
and run for 3, 5, 7 or 15 minutes (6, 14 or 30 for diesel engines), depending on programming. The
remote-starter will repeat this sequence for up to a maximum of 24 hours. For manual transmission
vehicle’s READY MODE must be enabled, and if at any time READY MODE is disabled this sequence
will cancel.
WARNING Do not start the vehicle indoors (garage, underground parking).
To enable Cold Start Timer Mode proceed with the following steps.
+
Press and release the FUNCTION button, within 12 seconds
simultaneously press and and hold the LOCK and START
buttons for 1 second.
To disable Cold Start Timer Mode do any of the following:
•
Press and release the FUNCTION but-
ton, within 12 seconds to simultane-
ously press the LOCK and the START
buttons for 1 second until the parking
light fl ash twice.
•
Put the Remote-Starter/
alarm into Valet Mode.
Remote-Start the vehicle.
•
Open the hood.
•
Press the brake pedal.
•
Turn the key to the ignition
(ON / RUN) position.
•
Disable Ready Mode
(manual transmission).
Note : If the Alarm is triggered during Remote-Start (Cold Start), the vehicle will stop running, but Cold
Start will not cancel it’s schedule.
Page 9 / 14