CAUTION - WARNING
IT IS THE RESPONSIBILITY OF THE
REMOTE CAR STARTER OPERATOR
TO:
•
ensure that the vehicle is parked in a safe and responsible manner.
•
ensure that the vehicle is not remotely started indoors (garage, underground park-
ing).
•
ensure that the vehicle is not remotely started with a passenger inside.
•
ensure that the gearshift lever is in the NEUTRAL position and the parking brake is
engaged on manual transmission in order to avoid accidents upon remote starting.
•
when leaving the vehicle, ensure that the gearshift lever is in the “PARK” position for
an automatic transmission in order to avoid accidents upon remote starting. (Note:
Make sure that the vehicle cannot start in “Drive” position.)
•
ensure that the remote starter is disabled or put into valet mode before servicing.
When servicing the vehicle, enable valet Mode (via switch) / VALET CODING, page
8.
NOTE
•
The system can be confi gured in three different ways: Remote Start only, alarm only or alarm
and remote starter.
•
The options vary by vehicle, the components can be added to the system and the functions on
the vehicle.
INDUSTRY CANADA USER NOTICE
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifi cations to this equipment. Such modifi cations could void the user’s authority to operate the
equipment.
GOVERNMENT REGULATIONS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and can radiate
radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specifi cation RSS 210. Its use is
authorized only on a no-interference, no-protection basis; in other words, this device must not be
used if it is determined that it causes harmful interferences to services authorized by IC. In addition,
the user of this device must accept any radio interface that may be received, even if this interference
could affect the operation of the device.
Warning! Changes or modifi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate this device.
Page 3 / 14
Содержание ANT-FMH-2W
Страница 14: ...Page 14 14...
