Fortessa_FTK5_Instructions_Rev01
2
There are 600 user codes (fobs or cards) and 1 programming code:
Careful administration records will be required for future reference, please refer to last page of the instructions for an
example sheet.
Important Note:
If a code is required then this has to be programmed with a fob or card
To add fob or card
From quiescent state:
Constant Blue LED
(default)
Enter programming code: i.e.
1 2 3 4
,
1 2 3 4
(default unless changed) – Long beep, Yellow LED
Enter user ID from 001-600: i.e.
002
(alternating flashing green/amber)
if you hear a double bleep and constant green LED then
the user ID has already been programmed and will require deleting first before programming
Then:
Swipe card/fob
(single beep alternating flashing green/amber)
You can then swipe the next card or fob for the next consecutive User ID will be used.
To exit programming mode press:
#
To add fob/card and user code
From quiescent state: Constant Blue LED (default)
Enter programming code (default 1234):
1 2 3 4, 1 2 3 4
(unless changed) – Long beep, Yellow LED
Enter user ID from 001-600 i.e:
0 0 2
(alternating flashing green/amber)
if you hear a double bleep and constant green LED then
the user ID has already been programmed and will require deleting first before programming
Enter user code:
X X X X
- (X=Code) (double beep)
then Swipe card/fob
(beep)
You can then insert the next user code and swipe fob for the next consecutive User ID will be used.
To exit programming mode press:
#
Access Modes:
The keypad can operate in a choice one of 3 modes (default =
0
)
0: Either Fob/Card or code
1: Card only
2: Card/Fob & code required
From quiescent state: Constant Blue LED (default)
Enter programming code (default 1234):
1 2 3 4, 1 2 3 4
(unless changed)
Enter:
8 1 0 M
#
(M = above modes 0, 1, 2)
Note:
If a button is not pressed within 30 second the keypad will exit the programming menu
Careful administration records will be required for future reference, please refer to last page of the instructions for example sheet
