First Installation
12
Connecting to an existing power supply
Caution: POS-Line high bright monitors with an input voltage of 24V can only be used with a current source of limited power
(see standard EN 62368-1, chapter Q, table Q.1 “Limited power sources” with max. 24V / 4A 100VA).
•
Make sure that your external power supply is sufficient for the display. The maximum power consumption of the display is indicated
in the data sheet and the display label.
•
Disconnect the adapter cable, if necessary, the device and the power supply.
• Disconnect the green connector from the adapter cable.
•
Connect your POS-Line monitor to your power source. Pay attention to polarity of the green connector!
• Connect the green connector to the device.
•
Disconnector: The DC supply network can be disconnected via the Phoenix connector, at the POS-Line monitor.
Grounding the display chassis
The housing of the monitor is equipped with a function grounding. This can be connected optionally to the earthing of the system. Use
the connector on the bottom of the monitor as well as a ground cable with a sufficient cross-section (for example 0.75 mm²).
Power supply
GND
+24V
