10
10
3
Loosen the hex screws on top and bottom of the handle with the hex
wrench (provided) so that you can fit the handle over the extended
head screws in the door.
4
Place the door handle over the heads of the screws, then tighten the
hex screws.
Using your freezer
The storage life of frozen foods varies and the recommended storage time
should not be exceeded.
Place frozen food into the freezer as quickly as possible after purchase. If
there are instructions on the packet, carefully follow these instructions
regarding storage times.
Pre-packed, commercially frozen food should be stored in accordance
with the frozen food manufacturer's instructions for a three star frozen
food storage compartment or home freezer.
Shelves are provided for the organization of odd-shaped items.
1
Plug in your freezer. Wait for 30 minutes, then open the freezer door to
determine if the freezer is working properly.
2
Press and hold Lock for three seconds, then or on the control
panel touch pad to set the temperature inside the freezer. A beep
sounds when the MAX or MIN temperatures are reached.
Hex screws are here.
Extra hex screws are
Provided.
8
Finding a suitable location
t
Place your freezer on a floor that is strong enough to support the freezer
when it is fully loaded.
t
This freezer is designed to be free standing only, and should not be
recessed or built-in.
t
Allow 7.9 inches (20 cm) of space between the sides of the freezer and the
walls, 3.9 inches (10 cm) between the back of the freezer and the wall, and
11.8 inches (30 cm) between the top of the freezer and the ceiling. This
allows for proper air ventilation. Adjust the feet to keep the freezer level.
t
If you locate the freezer next to a fixed wall, allow sufficient space on the
hinge side for the door to swing open.
t
Locate the freezer away from direct sunlight and sources of heat, such as a
stove, heater, or radiator. Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent the freezer from performing properly.
t
Avoid locating the freezer in moist areas.
Leveling your freezer
t
It is very important for the freezer to be level. If the freezer is not leveled
during installation, the doors may not close or seal properly, causing
cooling, frost, or moisture problems.
t
To level your freezer, rotate the leveling feet clockwise (to raise) the freezer
or counter-clockwise (to lower).
Providing a proper power supply
Check your local power source. This freezer requires a 115V, 60Hz power
supply.
Use a receptacle that accepts the grounding prong. The power cord is
equipped with a 3-prong (grounding) plug which mates with a standard
3-prong (grounding) wall outlet to minimize the possibility of electric
shock hazard from this freezer. We recommend that the freezer be
plugged into an electrical circuit serving only this appliance and that the
circuit cannot be turned off with a switch or pull-chain.
Note
Have someone push against the top of the freezer to help take
some weight off the leveling foot, making it easier to adjust.
3-prong receptacle
Receptacle box cover
3-prong plug
Grounding lead
Grounding adapter Receptacle box cover
Screw
Receptacle
Using a 3-prong plug and outlet
Using a grounding adapter
