•Have you packed food of strong
flavors?
•Packing food of strong flavors.
•
The refrigerator
lamp being OFF.
•
Does the refrigerator door stay open?
•
Close the door and open it again, so as to
observe whether the refrigerator light up
normally.
(
Note: If the above descriptions are inapplicable to troubleshooting, do not disassemble and repair it yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact the local store where
your purchase was made. This product should be serviced by an authorized engineer and only genuine spare parts
should be used.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the
appliance, leaving the door ajar to prevent unpleasant smells.)
VIII.
Certifications
Electrical information
This electrical appliance must be grounded
This product is equipped with a plug, which is suitable for all houses equipped with sockets meeting the current
specifications
If the fitted plug is not suitable for your socket outlets, it should be cut off and carefully disposed of. To avoid a possible
shock hazard, do not insert the discarded plug into a socket.
This product complies with the EEC directives:
IX.
Safe recovery instructions
Disposal
Old appliances still have some surplus value. An environmentally friendly approach will ensure that valuable raw materials
are recycled.
The refrigerants used in your equipment and insulation materials require special handling procedures. Make sure there is
no pipe damage on the back of the equipment before handling.
Up-to-date information on the options for disposing of old equipment and packaging from old equipment can be obtained
from the local municipal office.
Reversing the Door Swing
1. Screw off the screws of the upper hinge cover, and
remove the upper hinge cover.
2. Screw off the three bolts fixing the upper hinge, remove
the upper hinge, and pry off the door shaft sleeve, magnet
and the proximity switch on the upper hinge cover.
3. Screw off the three bolts fixing the top box cover on the
left side, remove the box cover, take the wire harness out
of the hole, and transfer the door shaft sleeve from right
side to the left side for installation.
4. Lift up the refrigerator door by 1.97in to remove it.
5. Remove the front leveling foot, screw off the 4 screws
fixing the hinge, and remove the lower hinge.
