INSTALLATION INSTRUCTIONS
1 (6)Six Refrigerator Door Bins
(2)Two Refrigerator Shelves
(1)Refrigerator LED Light
2
3
4 (2)Two Vegetable Crispers with Glass Cover
(1)Freezer Drawers
(1)Ice maker Assembly Inside the Freezer Drawer
5
6
Before Using Your Appliance
• Remove the exterior and interior packaging.
• Check to be sure you have all the following parts:
• Place your refrigerator-freezer on a floor that is strong enough to support the refrigerator- freezer when
it is fully loaded. To level your refrigerator-freezer, adjust the leveling legs at the bottom of unit.
• Locate the unit away from direct sunlight and heat sources (stove, heater, radiator, etc.). Direct sunlight may
affect the acrylic coating and heat sources may increase power consumption. Extreme cold room temperatures
may also cause the refrigerator- freezer to not perform properly.
• Avoid placing the unit in a moist area.
• Plug the unit into an exclusive, properly-installed grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should
be directed to a certified electrician or an authorized FORNO Products service centre.
• Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system due to handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Appliance
※
The appliance is equipped with an automatic alarm which indicates that one of the doors of the appliance are
opened for a longer period of time.
1. If one of the doors is opened for more than 1 minute,an acoustic warning signal sound.
2. If the door is opened for a prolonged period of time, the acoustic warning signal will sound three times every
30 seconds.
The door alarm can
also
be quitted
permanently
by closing the corresponding door.
In order to save energy a prolonged opening of the doors should be avoided.
Door alarm
※
Long press"fridge"button for 5 seconds to set fridge compartment on/off,when fridge compartment is switched
off,the fridge temperature digital display will go off;under the fridge compartment switched off state,long press
"fridge"button for 5 seconds to restart fridge function.
Fridge compartment switch off/on
• ALLOW TWO
(2)INCHES OF SPACE BETWEEN THE BACK OF THE APPLIANCE AND THE
WALL AS WELL AS A MINIMUM OF TWO (2)INCHES AT EACH SIDE OF THE UNIT AND FOUR
(4) INCHES AT THE TOP, WHICH ALLOWS PROPER AIR CIRCULATION TO COOL THE
COMPRESSOR AND CONDENSER.
Minimum Space Allowances
Top
Four (4) inches
Two (2) inches at the back
Two (2) inches on each side
Sides
Back
