Troubleshooting
Problem
Possible cause
Dishwasher won't start
Solution
Shut the door completely and make sure it is latched
Power supply or power line is not connected Check and connect the power supply
Dishwasher won't start
Delay Start option has been selected
Child Lock activated
(selected models)
Dishwasher beeps at the end of
the cycle
Rinse Aid light on
This indicates that the wash cycle finished,
dishwasher will beep
LED screen shows “Lsb”
The dishwasher is connected to cold water
Add rinse aid
Check the dishwasher, make sure it is properly
connected to the hot water supply
When heavy soil is detected, the auto, normal,
pots and pans cycle will automatically increases the
cycle time
When the sanitize option is selected, the cycle time
will be increased to meet the sanitized temperature
requirement
Use your dishwasher when the water pressure is
normal
Make sure the dishwasher is connected to the hot
water supply
Try to not use your dishwasher when hot water is
being used elsewhere in the house
Load the dishes again as per the manual
Add detergent depending on the water hardness
and the cycle you chose. Use fresh detergent
Refer to Delay Start section in this manual to reset
Deactivate the child lock, refer to the child lock
section in this manual
Dishwasher operates too long
The cycle time will vary due to the soil level
The sanitize option is selected
Water pressure is temporarily low
The inlet water temperature is low
Dishes are not clean enough
Dishes are loaded too close together,
improper use of detergent
The selected cycle is not suitable for food
soil condition
Spray arm is blocked by items
Choose another cycle for longer washing time
Make sure the spay arm rotates freely
Fill rinse aid dispenser or increase the amount of
rinse aid.
Load the dishes again as per the manual.
Detergent dispenser is empty
Dishes not dry enough
Improper loading of dishes
The cycle you chose does not include
drying
Water hardness is too high
Spots and film on dishes
Improper loading of dishes
Old rinse aid is used
Rinse dispenser empty
Using too much detergent
Etching
The inlet water temperature exceeds 158
℉
Choose the proper cycle with drying
For extremely hard water, install a water softener
Load the dishes again as the manual indicates
Use fresh rinse aid
Add rinse aid to the dispenser
Use less detergent if you have soft water
Lower the inlet water temperature
15
