15
WWW.FORNEYIND.COM
•
Rotate the Idler Arm (K) inward into position and rotate the Tension Adjustment Knob Armature downward
until it engages the Idler Arm.
•
Ensure that the welding wire is centered in the lower groove of the drive roller.
Step 6:
Apply drive tension by rotating the Tension Adjustment Knob (G) clockwise until snug.
•
TIP:
More tension is not better! Use as little drive tension as possible while still feeding wire smoothly
and continuously.
Step 7:
Close mechanism and wire spool compartment covers.
Step 8:
Verify this setup by depressing the spool gun trigger.
•
Depressing the trigger should feed wire through the torch neck and out the nozzle of the spool gun.
Feed several inches to ensure smooth operation.
Step 5:
Feed the free end of the wire through the wire feed mechanism until it enters the inlet guide of the torch
neck.
