Forney 325P, Руководство по эксплуатации

Страница: 23 / 92

23 WWW.FORNEYIND.COM
TROUBLE EXPERIENCED POSSIBLE REASONS RECOMMENDED SOLUTION
Insufficient Penetration Cutting speed too fast Decrease your torch travel speed
Torch is too tilted Ensure that torch is perpendicular to the work
piece
Work piece is too thick Choose thinner work piece material within the
operational limits of the system.
Cutting current too low Ensure system has proper input power source
If used, eliminate or reduce length of extension
cord.
Torch parts are worn
out
Examine the consumables for wear and replace
worn parts with new Forney consumable parts
Non-genuine
Manufacturer’s parts
Use only genuine Forney consumables for
optimum performance
Interruption of the
Cutting Arc, but re-ignites
when triggered again
Cutting speed too slow Increase your torch travel speed
Excessive distance
between torch and
work piece
Decrease the distance between the torch and the
work piece
AC line too low -
reduce output current
Ensure system has proper input power source
If used, eliminate or reduce length of extension
cord.
Torch parts are worn
out
Examine the consumables for wear and replace
worn parts with new Forney consumable parts
Non-genuine
Manufacturer’s parts
Use only genuine Forney consumables for
optimum performance
Work cable is
disconnected
Securely clamp the work cable to the material
being cut, as close to the work area as possible.
Excessive Dross
Cutting speed too slow
(bottom dross)
Increase your torch travel speed
Cutting speed too fast
(top dross)
Decrease your torch travel speed
Excessive distance be-
tween torch and work-
piece
Decrease the distance between the torch and the
work piece
Cutting current too low Ensure system has proper input power source
If used, eliminate or reduce length of extension
cord.
Torch parts are worn
out
Examine the consumables for wear and replace
worn parts with new Forney consumable parts
Non-genuine Manufac-
turer’s parts
Use only genuine Forney consumables for opti-
mum performance
Tilted Cutting Angle
(not perpendicular)
Torch position not cor-
rect
Ensure that torch is perpendicular to the work
piece
Check torch consumables for proper installation.
Asymmetric wear of
nozzle hole and/or
wrong assemblage of
the torch parts
Examine the consumables for wear and replace
worn parts with new Forney consumable parts