26
- Install the pneumatic pump as di-
rected in paragraph 3.3. Bring the
air pressure to
0
(
zero
) making
sure all the air has been let out.
- Use a 10 mm socket wrench to
loosen the air valve (
2
).
- Turn over the fork and empty the
oil present in the air cylinder.
- Remove the rebound knob (
3
) by
pulling it up.
- Use a 4 mm hex wrench to loosen
the lock screws (
4
) and (
5
).
- Remove the lower leg by (
6
) pull-
ing it up.
- Push the piston (
7
) fully inside the
cylinder.
- Remove the retention ring (
8
)with
a small flat blade screwdriver (
9
).
- Remove the entire sleeve (
7
) with
the piston and spring assembly
from the cylinder.
- Place the sleeve (
7
) on a table with the piston
(
11
) facing down.
-Deviate the spring assembly (
12
) by pushing
on the plastic part and not directly pulling the
springs. Release the retainer that holds the
spring assembly.
-Insert spacers (
13
) where needed, as shown
in the figure, and then engage the retainer
again.
3
4
5
6
9
8
7
7
10
12
