11
9.
Replace the table top.
10. INSTALL THE COVER
11. Remove the lock outs.
12. Restore power to the machine.
!
1. DISCONNECT POWER.
2. Install lock outs to prevent accidental start up.
3. Remove the cover.
4. Unscrew and remove the right hand side table top section. This will expose the auxiliary shafts
on which the rolls will be mounted.
5. Select the first pair of rolls which are marked T1 (Top roll first station) and B1 (Bottom roll first
station). Slide them as a mated pair onto the shafts. All information stamped on the rolls must
face outward. Slide a key into each key seat. Follow this this procedure in sequence with each
remaining pair of rolls.
6. Fasten all rolls except the top number 2 onto the shafts with the screws and washers provided.
Do not insert a mounting screw into the top 2 rollshaft; this allows the roll to “float” laterally, and
center itself to the bottom roll as the stock passes through.
7. Mount the entrance gauges so that the centerline of the stock aligns with the centerline of the
rolls.
8. Tighten the stud nuts so that the T5 and B5 rolls do not separate as the drive cleat passes
through.
9. Mount the exit gauge so the outside face of the vertical leg is parallel to the part as it passes
over the exit table. Set to allow approximately 1.5mm clearance between the part and the exit
gauge.
10. Replace the table top.
11. INSTALL THE COVER.
12. Remove the lock outs.
13. Restore power to the machine.
IMPORTANT:
BE SURE TO CUT STOCK EXACTLY 54mm (2
1
/
8
”
) WIDE TO INSURE AN
ACCURATELY FORMED CLEAT.
DRIVE CLEAT ROLLS
!
!